Walther Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter · #1 · (Edited)
SOLD: Magwell from Q5 Match Steel Frame Pro

SOLD

This is a low profile lightweight aluminum magwell pulled off a new and unfired Walther Q5 Match Steel Frame Pro. These low profile magwells are not available anywhere but on the Steel Frame Pro model. This magwell will fit on a Q5 Steel Frame without modification, and will fit on any plastic framed PPQ or P99 of any generation with minor modification*. However the magwell must be used with aluminum base plates, available from Walther or Taylor Freelance in +0, +2 or +6 sizes, it will not fit standard plastic PPQ mag baseplates!

SOLD

*Edited to clarify compatability, I tested and confirmed that this magwell will fit a PPQ or a P99 with different modifications for each:
To fit any plastic frame PPQ, a simple modification must be made to the backstrap only with no modification to the gun or magwell.
To fit any plastic frame P99, a small modification must be made to the backstrap as well as to the frame of the gun, but not to the magwell.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top