Walther Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
Anyone know where I can get two of the nickel or SS flat magazine floor plates for PPKS 380? I got two of the ones that have the finger rest and they suck. I'd like to get the regular flat floor plate before I toss these POS out.
 

·
Registered
Joined
·
26 Posts
Discussion Starter #3
I'll give them another try tomorrow. Seemed like the ones with the firger rest did not seat properly. Figured it was either me leaning on the plastic too hard or the plastic interfering with it seating.

I found for concealed carry, the flat floored mags concealed better too.

If I do get rid of them, I'll offer them here first rather than tossing them.
 

·
Registered
Joined
·
713 Posts
When their seated their is a small gap between botton of grip and finger rest. Check and see if catch is going all way in. Hole in mag might need to be open slightly. Just trying to save you some $ as these mags are as much as my 45's. I only use Factory mags for carry in my auto's except for 45's then their are several brands . I agree the mag with plain botton conseals a little better.
 
1 - 4 of 4 Posts
Top