Walther Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
178 Posts
Discussion Starter #1
Last time I had the P22 out at the range I noticed during cleaning that I was getting wear marks of the slide. They occur on both sides forward of machined rails that hold onto the frame. Is this normal? Should I be concerned? Can I post pictures or do I have to email them to interested parties?
 

·
Registered
Joined
·
471 Posts
Are the wear marks resulting from the steel ears on that strut assembly that's attached to the trigger? If so, then it's normal... It's not good, but it's normal... The slide is made from Zinc and is much softer than the steel of said component... I rounded the tops of those little ears to minimize the wear...
Pictures would help. Use a free web host and link to them. Photo bucket or Imageshack will work...
 
1 - 2 of 2 Posts
Top