Walther Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter #1
Hi. first post here and I couldn't find an answer anywhere so hopefully someone will be able to help me out. I recently purchased a P1, nothing special, just a fun shooter. I decided to get it refinished in cerakote. I stripped it down as far as possible but I am stuck how to remove the last few things.

Pin and spring from safety catch
Plunger and spring for retainer latch
and most importantly, removing locking block operating pin

Thanks
 

·
Premium Member
Joined
·
26,071 Posts
Did you check out the Sticky threads in the FAQ section on how to reassemble these pistols? You have your pick of more than one. Hope that helps.

Welcome aboard; enjoy your time here.
 

·
Registered
Joined
·
31 Posts
Discussion Starter #4
I figured out how to remove the pin and spring from the safety catch. On the safety catch there is a very small hole, insert a 3/8ths punch and push, it should come out.

To remove the locking block operating pin I used a punch to gently tap the pin towards the muzzle.

Still stuck as to how to remove the plunger and spring for the retainer latch.

Anyone???
 
1 - 6 of 6 Posts
Top