Walther Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
Good news guys. I took a gamble that paid off. I just finished installing Truglo tritium sights on my Creed. I bought front and rear sights that were listed for both P99 and PPQ. Using a sight pusher, I removed the rear sight from right to left (as you would sight the gun). It took a fair amount of pressure. I removed the front sight using a small flat blade screwdriver. The Truglo rear sight came with a hex set screw and the hex key. Again using the sight pusher, I installed the rear tritium sight. It went on fairly easy. Using a bit of red locking compound, I painted the set screw and hole and snugged it up. Finally, I installed the new front sight with a flat bladed screwdriver and applied red locking compound. I found that I needed to use the screw that came with the Truglo kit, rather than the original screw.
Good luck!
 

Attachments

1 - 1 of 1 Posts
Top