Walther Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I'm trying to replace the factory sights with Trijicon HDs. However, the tool I have (3/16'' hex) won't fit through the hole in the bottom of the 5'' slide. Has anyone changed theirs out? If so what tool did you use to install the Trijicon front sight? Thanks in advance!
 

·
Registered
Joined
·
97 Posts
I installed the Trijicon HDs on my 5" PPQ and I could not get a 3/16" hex tool to fit even after grinding the sides down.

I got the sight screw started and then used a small punch to tap the flats if the screw to tighten the sight screw, that was over a year ago and it has never come lose.

It would be nice if Trijicon would offer a smaller sight screw head for the 5" PPQ's
 

·
Registered
Joined
·
3 Posts
Discussion Starter #4
Thanks for the advice guys! Did the sights change your POI at all? I've heard it can possibly make it lower.
 

·
Registered
Joined
·
198 Posts
the right tool for the job makes all the difference in the world
 
  • Like
Reactions: tamidar
1 - 6 of 6 Posts
Top