Walther Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
232 Posts
Discussion Starter · #1 ·
I just noticed on my P99 that the roll pin at the top of the trigger blade (right up against the frame) was on its way out on my gun. I drove it back in easy enough but I thought I'd let you know to check yours.
 

· Registered
Joined
·
232 Posts
Discussion Starter · #3 ·
Acually this one's the one that holds the trigger plate on. On the blown up photo from the P99 FAQ it doesn't even have a number. If the hole opens up a new pin wouldn't help, but it was a bit snug being pushed back in. I've only got about 2500 rounds though it so far too. I'm gonna keep my eye on it too, if it's worse, I'll send it to Walther under warranty.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top