[freshmeat]

Does anyone have a line on someone very repuatable who can thread my TPH? I have seen several of them done and AAC even has a pic of one with thier "Stinger" suppressor on the website, but I cant seem to find anyone who is willing or has the know how Getting discouraged!

 

[uncut]

http://noveskerifleworks.com/cgi-bin/imcart/display.cgi?cat=3
I think a member on this board used them for some work .....

and then there is Gem-tech.... not too sure about these guys as the last time I talked to them they were pretty filled with workorders
http://www.gem-tech.com/

 

[freshmeat]

http://noveskerifleworks.com/cgi-bin/imcart/display.cgi?cat=3
I think a member on this board used them for some work .....

and then there is Gem-tech.... not too sure about these guys as the last time I talked to them they were pretty filled with workorders
http://www.gem-tech.com/

Thanks!

Yes, your correct about Gemtech; they owe me two suppressors they should have shipped over 4 months ago. I would not recomend them at all. & I actually just had some theading done by the outfit they are outsourcing to: "Aquila". problem with that place is that the guy seems very unknolledgable about threading handguns, however he did excellent work..its just how he goes about it I'm concerned with, & he's in another state so not like I can go down there and show him what I need done. I have also tried AAC, AWC and Trousa, all with no luck.

Going to try sending novesk a note right now!

Thanks again! B.