Walther Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I have a TPH 22 that breaks the take down safety. Also referred to as trigger guard safety. Not sure why. But when I put the part in and hold in place with a paper clip (smaller diameter than the pin). the part sits flush in channel. When I use the pin, the part sticks out into the mag well a little. Any thoughts?
 

·
Registered
Joined
·
603 Posts
Do you have piece placed in there backwards?
 
  • Like
Reactions: MGMike
1 - 3 of 3 Posts
Top