Walther Forums banner
1 - 5 of 5 Posts

· Registered
306 Posts
It's not that difficult (I did it) but :

- I left the hexagonal (transversal) reinforcement pin in its place
- take care while removing the recoil springs : you should "screw" them out backwards.

As for the rest, no problem (keep an exploded view at hand for correct assembly of some parts afterwards, especially for the springs behind the grip panels)

Good luck
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.