Walther Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
177 Posts
Discussion Starter #1
Anyone know how to disassemble the slide and firing pin. I would like to break it down and clean the channel and pin. Anyone taken the armorers course on the P-99? I may try and get into the Dec class. I have taken five different armorers courses on different pistols and revolvers like to add the P-99 to the list.
 

·
Registered
Joined
·
177 Posts
Discussion Starter #3
Thanks Venom600, I just cleaned out the channel and cleaned up the striker pin. I had a FTF today with a round and my gun has about 2,000 rounds through it. I tried twice to shoot the round and it had a decent hit, it should have went off but it didn't. I put that round in my Glock 17 and bang. So I wanted to check to see if there was a build up in there. Cleaned it out with hoppes and then gun scrubber and left it nice and dry. It could have been a deep primer, who knows. Anyways thanks for the advice, I should have looked in the manual.
 

·
Registered
Joined
·
12 Posts
cocojo, I hope you don't mind I tag an additional question to your post.


On a related matter.... are there instructions online for detail stripping the frame of a P99?
 
1 - 4 of 4 Posts
Top