Walther Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
Trying to install TRUGLO TFX Pro sights on my PPS M2. The front sight tang seems a little too big for the front sight's oblong hole on the slide. Any suggestions?

I'm going to break out the heat gun and warm up the front of the slide to see if that helps.

Sent from my SM-G975U using Tapatalk
 

·
Registered
Joined
·
136 Posts
Discussion Starter · #2 ·
Warming up the slide helped. I was then able to push the front slight in. The screw head seems a little small. Is that normal?

I have a sight pusher and was able to do the rear sight in about 10 minutes with being careful not to scratch anything. Need to shoot it for accuracy and adjust as necessary before locktite'ing anything.

-- Mark
 
1 - 2 of 2 Posts
Top