Walther Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
191 Posts
Discussion Starter · #1 ·
I normally use two 6 inch round bulls eye targets - one above the other. have noticed I seem to shoot the lower target at same range better.


today, shooting P911, shot lower target well-switched to higher target, and missed the whole target 5 shots all high. Advice welcome. Must not be holding sights on higher target correctly. Help
 

·
Registered
Joined
·
191 Posts
Discussion Starter · #3 ·
P911

I tried dry fire tonight with this gun,,when I aimed at a vase higher than my normal dryfire target, I noticed my front sight was higher than the rear sights....think that is it. tried with my Walther PPQ4 & no problem. Maybe, with the P911 being so small, the sights are as I described unless I Pay more attention.
 

·
Registered
Joined
·
122 Posts
Is the rear sight adjustable? If it is lower it. Reading your post about your taurus and you said it was accurate. Maybe your rear sight has risen or needs to be tightened down if it has a allen screw.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top