Walther Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I am new to all this so bare with me.

I have a PPS - 300-400 rounds thru it. I clean it each time and have never had an issue putting all back together. This time however I cannot get the slide to rack back all the way.

I think it is the Trigger assembly getting caught up on the striker safety. How can I get the arm of the assembly lowered so I can put this puppy back in order again.

Steve
 

·
Registered
Joined
·
250 Posts
Remove the decocking backstrap. Also, you can gently push down on the back of the slide or push it to the left during reassembly to overcome resistance points.

If your problem is with fully retracting the slide after it is on the gun, then make sure the recoil spring assembly is properly aligned vertically.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
This worked, thanks guys.

After reading Dmars suggestions I wonder if there is a video of this process. I am still new to most of the terminology and would love to "see" this process in action.

Thanks again.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top