Walther Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
Where can I get a new slide release lever? I have a P99 that had it's slide release bobbed off a bit and I'd like to restore it to factory specs....
 

·
Registered
Joined
·
67 Posts
I would try the Walther parts service run by S&W. I used them once and found them to be courteous and helpful on the phone, and they sent me the parts ASAP. You can reach them at (800) 331-0852 X2905.

Good luck.
 

·
Registered
Joined
·
30 Posts
I second the Smith & Wesson Idea...When I wanted to get the new third gen Magazine followers for my S&W 99/.40, they were very nice and sent them to me for free and they were very nice about it....not like pulling teeth like some manufacturers I can think of.

Smith's Custermer service is the easiest to deal with of the the bunch.
 

·
Registered
Joined
·
187 Posts
Replaced my Guide spring assembly last year, after a few thousand rnds. Got it quick from S&W.
 
1 - 4 of 4 Posts
Top