Walther Forums banner
1 - 1 of 1 Posts

27 Posts
Discussion Starter · #1 ·
I just swapped the sides that my magazine release button is on. It is not that difficult, but takes a 1mm punch and a little finesse.

Put the punch in the small hole on the mag catch opposite side at about a 45 degree angle (you have to push the mag catch all the way in to see the hole).

Press on the punch while lifting the plastic cap opposite the hole (it actually has a fingernail groove to do this).

If you do it right, the plastic cap pops up and you can remove the punch and slide the mag release out towards the button side.

Swap it around to the other side (make sure the spring is in the right place), and press the cap back into place (make sure it clicks)

I have a youtube video, which may help:

Good luck.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.