So I've had my PPS M2 for a while now. The rear roll pin has constantly crept out ever so slightly to the right, only to point that it becomes irritating because it starts biting my hand when I shoot. I have always been able to push it back in with a press but it does eventually work its way out after a few rounds. Any thoughts or similar occurances?
Yeah, not sure if this is worthy of mention to Walther for sending in. I've been hitting it in recently with a punch and hammer. Just about every range session it creeps out. Definitely right about it being sharp and annoying.
Yeah, not sure if this is worthy of mention to Walther for sending in. I've been hitting it in recently with a punch and hammer. Just about every range session it creeps out. Definitely right about it being sharp and annoying.
I emailed Walther last night about the problem. Sent your picture instead of taking my own. Thanks, they look identical. I tried to reset the pin but it didn't want to move with a few taps from a brass hammer. Don't want to break the plastic frame.
They want me to send it in for repairs. Pain in the ass, but they're giving me prompt service and I assume free shipping. I'll let you know how it works out.
I emailed Walther last night about the problem. Sent your picture instead of taking my own. Thanks, they look identical. I tried to reset the pin but it didn't want to move with a few taps from a brass hammer. Don't want to break the plastic frame.
They want me to send it in for repairs. Pain in the ass, but they're giving me prompt service and I assume free shipping. I'll let you know how it works out.
Much appreciated bass, thanks for the update.]
so:
Sent the PPS to Walther last Friday. They repaired it and returned it today, one week total. Repair included new trigger assembly, sear pin, and sear housing assembly.
Total cost with shipping and labor invoiced at $170.98.
My cost $0.00 Plus a week waiting for the gun.
Glad I didn't just let this one ride. Thanks Walther. Great warranty.
Edit. Trigger is also much smoother. Feels fine tuned.
While waiting for my approval for a suppressor and having my barrel sent out to be extended and threaded, my question is will my choice of suppressor require a nielsen device for proper operation.
I purchased a PPS M2 back in January. I cleaned and lubed it and took to the range. I fired 127 rounds of various ammunition. I had 5 failures. 3 fail to ejects and 2 fail to load. The ones that wouldn’t load were hollow points. I am thinking that the edges were getting hung up in the gap of...
Hello,
I read the owners manual on how to disassemble the extended magazine (medium or large floorplate) for the PPS M2. The first step is to use a small screwdriver and lift the Dust Cover's left and second its right front end gently a little bit (0.04") off the floorplate. Next it says lift...
Hello,
Last week I purchased a Walther PPS M2.* So far I shot a total of 100 rounds through it.* After cleaning my Walther PPS M2 I noticed there was a peening mark on the right side of the barrel near the feed ramp.* Is this normal? *Is this going to damage my gun? Will I need to sent it out...
A forum community dedicated to Walther firearm owners and enthusiasts. Come join the discussion about performance, gunsmithing, troubleshooting, reviews, accessories, classifieds, and more!
