Walther Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hello,

I read the owners manual on how to disassemble the extended magazine (medium or large floorplate) for the PPS M2. The first step is to use a small screwdriver and lift the Dust Cover's left and second its right front end gently a little bit (0.04") off the floorplate. Next it says lift the Dust Cover rear plate.

I'm having difficulties with this step of the magazine disassembly and I'm not sure how to remove the Dust Cover off the magazine. The picture in the manual makes it look easy but I'm having a hard time on this step. Are there any posted videos (like youtube) about the full magazine disassembly? Or would anyone be able to help share some helpful advice?

Thank you
 

·
Registered
Joined
·
5 Posts
If you are speaking of re-moving the dust cover from the magazine, you can see it done at the MagGuts.com website, in the support section.
Working on PPS-M2 7/8rnd magazines a video shows how to remove and then re-install the dust cover that "seals" the 7/8 rnd mag floor plates.
 
1 - 2 of 2 Posts
Top