[RegisG]

Looks like these 2 guns (PPQ 9mm & PPQ 22) are "almost" the same size. Does anyone know which backstrap on the PPQ matches the size of the PPQ 22 grip? And, are the grips the same width? I don't think the 22 has other backstraps???


My PPQ 9 will arrive tomorrow and want to set it up to begin with, like the 22. I'll opt for backstrap fit if not close. Will get 22 in few months

I've got the small on my Q5 but, medium would probably work ok.

Thanks,
Regis

 

[Kar98]

The PPQ 22 has no backstraps to fiddle around with, and the PPQ 9mm with the smallest backstrap is the closest in shape to the 22.

 

[Balor]

I think what Kar98 has said is correct. I have both, but I can't give you accurate measurements as the 9mm has the large backstrap covered by a Talon adhesive rubber grip. The width is also difficult to state accurately because of the bulges, but here goes anyhow:

PPQ 9mm (with Talon): Width: 32.8mm; Circumference: 14.5cm

PPQ .22 (no Talon): Width: 32.2mm; Circumference: 13.8cm

(Width and circumference measured directly below trigger-guard).

In shooting practice, I don't feel that it makes much difference.

Although the build quality is not on a par with the 9mm, the .22 is a nice little shooter - when you've found ammo that it likes (and keep it clean). If you buy a new one, make sure to clean all the gunk out before use.

Balor

 

[RegisG]

Thank you both, Kar98 & Balor

I'll be getting one and I always clean new guns but, thanks for the reminder.

Regis