Walther Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
336 Posts
Discussion Starter #1
I have an Interarms PPK that I purchased used a couple of weeks ago. I noticed that the loaded chamber indicator was not under spring tension so I disassembled the slide. The long arm of the spring was not seated but I have no idea how the spring should be seated. Can anyone tell me how to install the loaded chamber indicator properly?
 

·
Registered
Joined
·
178 Posts
Do a search for "Signal Pin" in the PP/PPK area
There's a post from a while back Started by Flusher were the info was talked over plus pics, diagrams & Links..
For some reason I found the post but it had no specific address just WaltherForum.Com? I'll post to it & bring it back to the top for you!!
Good Luck & Notice that PPK & PP/PPK/S are different as the spring is reversed..
I'd guess you need a new Loaded Cylinder Indicator Spring... I've seen this on a few PPKs I've handled as I thought they were loaded but the Pin had no tention..
Good Luck!
 
1 - 6 of 6 Posts
Top