Walther Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I was wondering if anyone would be interested in any sort of length of stainless polygonal o-ring barrels for their p99. I will start producing in the next month if there is enough interest. Price would be around $275 shipped. If seriously interested please email me at [email protected] so I can get a handle on how many I would be producing.
Thanks,
Brett Walker
Walker Tactical Systems
 

·
Registered
Joined
·
45 Posts
Brett, pardon my ignorance, but what, other than being of stainless steel, would be the advantage of such a barrel? thanks. Kyle
 

·
Registered
Joined
·
411 Posts
Polygonal would theoretically give you higher velocities.
Stainless would theoretically give you more corrosion resistance.
O-Ring would theoretically give you tighter more consistent lockup for better accuracy.
The only thing not theoretical, is you'd definately be out $275.
My factory P99 shoots plenty straight, hasn't rusted, and +p's have plenty of punch. And I have $275 in my pocket for more ammo.
 

·
Registered
Joined
·
45 Posts
Thanks Jody, and thanks again for turning me onto P-99's, I'm a true believer. Kyle aka farranger, and most especially aka catboy. take care,
 

·
Registered
Joined
·
41 Posts
For 275 dollars you could have
1. P22 with extra clip
2. Ruger MkII
3. A used CZ-75B
4. 2 High Point 9mms
5. A few cases of 9MM ammo
6. 4 sets of night sights
7. A night or two in Vegas
8. Half of a 1911
9. Barsto barrel and some change.
 
1 - 6 of 6 Posts
Top