Walther Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Hi all,

Just came back from the range with my new PPQ m2 and was very pleased. Slight tweak of the rear windage (2 clicks) and I was spot on l/r.

I fired about 200 rounds - mostly 147g reloads with 3.4g TiteGroup pushing them. I observed very consistent impacts about 2 inches (at 15 yrds) to about 1-1.5 inches (at 10 yrds) above point of aim. (I am accustomed to sight picture #2)

Very similar results with Factory Aquila 124gr.

Using 115gr (4.3 g TiteGroup) reloads @7yds and 10 and 15 my impacts were right on...(#2)

1) Nothing earth shattering, just wondered if others had experienced high impacts using OTHER than 115gr projectiles and stock sights.

2)Any Dawson precision sight user feedback with 115g, 124gr, and 147g holdover/under?

Thanks for the feedback!

Todd
1st Post.

http://i1108.photobucket.com/albums/h401/Talan2000/photo15.jpg
 

·
Registered
Joined
·
69 Posts
My 147 gr reloads have a similar POI vs lighter factory stuff. 147 gr factory - at higher velocities - are closer to POA = POI. IIRC, the very limited amount of 115 gr factory I tried was a little below POI at 10/15 Yds.
 

·
Registered
Joined
·
323 Posts
My 147 gr reloads have a similar POI vs lighter factory stuff. 147 gr factory - at higher velocities - are closer to POA = POI. IIRC, the very limited amount of 115 gr factory I tried was a little below POI at 10/15 Yds.
Same results here, my 147s are at POA, lighter bullets are a little lower. (that's with Dawson's)

Chuck
 
1 - 3 of 3 Posts
Top