Walther Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Anyone has luck installing Pachmayr grips on a current (made in Ft. Smith, AR) PPK/S ? Have the correct P/N 03478 for post S&W models, but a) material isn’t wide enough to encase the frame & b) screw appears to be too short.
98197
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
It looks like you have a PPK grip. They won’t fit the PPK\S frame.
Determined that the Pachmayr grips specifically state they were designed for PPK/S manufactured by S&W. My PPK/S was manufactured at the Walther facility located at Ft. Smith, AR, and it appears it has a slightly larger frame than the S&W version. To my knowledge, Pachmayr doesn’t make a grip for a PPK/S manufactured in AR.
98347
 
1 - 3 of 3 Posts
Top