Walther Forums banner

P99c owners

1K views 5 replies 4 participants last post by  ikiddp5 
#1 ·
If you have a P99c with a short magazine release, look at the bottom of the trigger guard, viewed from the bottom of the weapon. You can see a very faint line that matches the longer cut-out of the longer magazine release that is now used. Interestingly, my 2004 P99 (full-size) lacks this faint line.
 
#2 ·
+1
both mine P99c and P99 are 2004 (AE)

The fine line is much more visible on the right side of the triggerguard though...... (correct right side not when upside down)


*edit... good to have you back here Doc... been some time since I seen any posts from you on this board
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top