Walther Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
356 Posts
Discussion Starter · #1 ·
If you have a P99c with a short magazine release, look at the bottom of the trigger guard, viewed from the bottom of the weapon. You can see a very faint line that matches the longer cut-out of the longer magazine release that is now used. Interestingly, my 2004 P99 (full-size) lacks this faint line.
 

· Premium Member
Joined
·
4,588 Posts
+1
both mine P99c and P99 are 2004 (AE)

The fine line is much more visible on the right side of the triggerguard though...... (correct right side not when upside down)


*edit... good to have you back here Doc... been some time since I seen any posts from you on this board
 

· Registered
Joined
·
174 Posts
Have new pictures Mr. Lunde?
 

· Registered
Joined
·
4,353 Posts
[b said:
Quote[/b] (uncut @ Nov. 11 2006,10:47)]+1
both mine P99c and P99 are 2004 (AE)

The fine line is much more visible on the right side of the triggerguard though...... (correct right side not when upside down)


*edit... good to have you back here Doc... been some time since I seen any posts from you on this board
Yes, me 2
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top