Walther Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
525 Posts
Are you giving it adequate force when you're putting the slide back on. The slide on my compact goes back on super easy - I never pull hard enough to cock it even, but on my full size takes a little more force and winds up cocking every time. Perhaps yours is just a little more snug fitting.
 

· Registered
Joined
·
525 Posts
Looks like right around 1cm maybe a little less from the main rail.  Can you see any abrasion points on the frame with the slide off?  Dumb question but do you have the mag out when you're putting the slide back on?

Specifically I'd look at the small front and left side of the raised portion of the frame directly under the ejector above the warning in german. On both my full sized and compact you can see where its been chewed up by the slide some.   Perhaps some very gentle smoothing and a touch of grease here would help you out if you see the same.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top