Walther Forums banner
1 - 2 of 2 Posts

· Registered
12 Posts
Discussion Starter · #1 ·
Any one out there want to share their pet 9mm accuracy
load for their P99?

I am shooting a 106mm factory barrel:

115gr JHP - 4.5gr WSF OAL 1.085

Groups just under 2 inches at 25 yards.
Shot SA strong hand barricade.

This is a very light load, for punching paper (PPC).
It may not cycle with the factory spring if the
temperature is near freezing.

I have not chronographed this load yet. But I can guess
is just in the 950 fps range. Definitely less than 1000fps.

· Registered
16 Posts
The best accuracy that I have reached is with AA-7 at 8.0-8.3 gr. Using either a Sierra 125 JHP or a Hornady 124 gr TMJ-FP or XTP I can routinely hit a 1 inch dot at 30+ feet. This round is extremely accurate and at 1100+ fps is not a real light load. I prefer to re-use my own brass or buy once fired nickel brass in large quanities to insure good case quality. All loading is done with Winchester primers and COL set at 0.020" less than engaging the rifling.

FYI - our 2 P-99's are not accurate if you use low quality once fired brass that passes SAAMI gages, but causes a coke bottle shape. Additionally many other 9 mm's where friends were questioning their own gun's accuracy also loved these rounds.

Good luck
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.