Walther Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
Do they work?

I ask cuzz I saw and add for 10 round P88/P99 9x19 mags. Says they have slightly different floorplates than std P99 mag.

If the 10 rounders work in both, would the hicap preban P88 mags work in both too?
 

·
Registered
Joined
·
19 Posts
I use the 10 rd P88 mags in my P99 all the time.
The steel tube is the same, just the base is slightly longer.

My fix to stop from over driving them into the gun was to drill a 1/16" hole through the rear rib and insert a roll pin that is long enough to stick out each side and act as a stop.

I use them as my match mags. I'll let them get trashed instead of my factory P99 Mags.

If I get a chance when I get home I will post a picture.

The P88 compact Hi Caps would work,but they are the same length as the 10 rounders, no way to stop over driving them.

Sam
 

·
Registered
Joined
·
411 Posts
[b said:
Quote[/b] (sigma40sw @ Aug. 08 2003,4:08)]The P88 compact Hi Caps would work,but they are the same length as the 10 rounders, no way to stop over driving them.
Go to the auto parts store, and get a thick O-ring about 1" in dia. then slip it on the mag and down against the floor plate.
Now you have a stop on the P88 compact mags.
 
1 - 3 of 3 Posts
Top