Walther Forums banner

P22 Slide Catches on Hammer

3189 Views 7 Replies 5 Participants Last post by  JDog
Has anyone ever had the hammer ground down to reduce the frequency with which this happens?

Essentially, what is happening is the slide fails to cycle becuase it gets caught up on the hammer when it cycles.

It is not that big of a deal, mostly a minor annoyance as I have to release the slide manually, but it just shouldn't happen.

I have read that you can have the hammer ground down a little so that it no longer catches the slide while cycling. Has anyone ever had this done?
1 - 1 of 8 Posts
Check the Walther forum over at http://www.rimfirecentral.com. There are a few stickies at the top pertaining to issues with the P-22.
1 - 1 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.