Walther Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
828 Posts
The attaching animation process shows lining up the lower dot on the back strap with the lower dot on the frame then pivoting the back strap to align the upper dot on the back strap with the upper dot on the frame. Then completing the back strap attaching process. I did not pickup on the pivoting action from reading the manual. This animation is outstanding. Thanks for posting it.
 

·
Registered
Joined
·
136 Posts
Discussion Starter #3
I'm glad it helped! Can't figure out why Walther USA doesn't post this on their website. Here is the photo from the owner's manual:


Without paying attention, I was installing by the order of step 1, 3, 2, which worked on small backstrap but not the large one. However, following the proper order (1,2,3), both backstraps should lock on tightly.
 

·
Registered
Joined
·
33 Posts
I'm trying to do this with the large one but for some reason when I line the dots, it doesn't move up and snap on. I see with both backstraps, there's a thing that sticks out. Where does that fit in? I can't get over that the manual doesn't address this more clearly.
 

·
Registered
Joined
·
1,439 Posts
Thanks PPS21!!
 
1 - 6 of 6 Posts
Top