Walther Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
382 Posts
Discussion Starter · #1 ·
i was cleaning my P99 today, german variant.........and i bumped the rear site, and i noticed it move just a tad. This is not acceptable, its not a large movement but it does move a bit, is there anyway to tighten them down?
 

·
Registered
Joined
·
229 Posts
I have two P99s and both rear sights move a tiny bit, but I would consider the amount to be insignificant. It's not enough for me to fret about it.
 

·
Registered
Joined
·
382 Posts
Discussion Starter · #3 ·
yes, after posting this, i looked at it a bit closer and realized there is a spring operated tension pin that has a groove across it like a screw head that acutally holds the sight in place and its because of the width of that groove the sight is allowed to move a bit. Your right, its not much, no biggie....
 
1 - 3 of 3 Posts
Top