I swear that is my roll of tape and old drift. If I had one of these pistols I would have pulled it apart on the way home to see how it works. Really hard huh? I had to laugh at the comment about the take down. For over ten years I've listened to how hard it is to reassemble the P22 slide due to the long recoil spring. No it isn't, couldn't be simpler if you reinstall as Walther suggests.
If you go to all the trouble to make a long video like this....practice with a short segment and get the light and focus right. I haven't had a chance to see the whole video but it looks good from what I've seen so far. Thank you Ekjunge for tracking this down and posting. It should have been at WaltherForums first. Hope he is a Member here. M1911
I'd suggest an owner install the retaining pins for the front and rear assembly before trying to install the slide though.
After a couple of practices, I will suggest to take the system housing out first then the barrel/trigger mechanism out second. The design is actually very simple. Just the small parts are little harder to put back. Need to be careful.
It looks like the part most likely to be damaged is the magazine lock spring if you aren't careful when aligning that. That fellow was a little rougher on disassembly than I like. Prying parts out of the pistol like he did. You have to be careful how you pry the rear assembly out, especially in polymer pistols. Round rods do not have much bearing surface and can easily sink into and damage something softer.....including zinc or aluminum or polymer. M1911
There is no need to take out the trigger barrel assembly. Leave it in place. The trigger bar lifts right off as you pull out the rear assembly. You then need to place it under the cylinder but above the lip milled into the rear assembly when replacing your rear assembly
Okay stuff you should know.... When you pull the pin that holds the sear and drop safety , and the other pin that holds the ejector, you need to get them COMPLETELY seated.. Otherwise the tolerances are close enough that the slide won't cycle smoothly. (Apparently it ain't no Glock). Keep tapping them in until they are flush.
I am looking for a Cross Draw Driving holster for my CCP with a LaserMax rail mounted laser. I have looked at every holster website I can find with no luck. Any recommendations would be greatly appreciated. Thanks
well i just got my ccp back today and they took care of the recall, and it feels good looks like that they did replace a few things and the trigger feels better than when i gave it to them,i sent this gun to them spotless it came back dirty disgustingly dirty.filthy, foul, nasty, just wished...
Exploded parts diagram.
CCP Service Manual See page 12 for information on +P and +P+ ammo usage...
So someone asked me on the CCP Facebook group as to how hard it was to field strip the CCP. So I made a video showing me stripping down and re-assembling my gun. I don't make videos like this often (ever) so I can't claim great camera work. But here is a link to my video...
Sent from my...