Walther Forums banner

Interarms/ranger ejector needed

738 Views 7 Replies 6 Participants Last post by  TheWatcher
Hey guys,
After a run of over 3k rounds looks like my ejector broke on my ranger built interarms 380. Numrich doesn’t list one...any ideas on a replacement?
1 - 8 of 8 Posts
There are several on ebay right now. I have been meaning to pick up a few more myself after using my last ranger ejector on my last build. Just make sure that it it post 70's production because prior years were machined differently and will not fit.
  • Like
Reactions: 1
This seems to be a recurring need across Interarms PPK's. Is this a market opportunity for someone with machining skills? How difficult would it be for someone with the skills and equipment to make these?

PF
  • Like
Reactions: 1
...
After a run of over 3k rounds looks like my ejector broke on my ranger built interarms 380. ...
Where did it break?

M
There are several on ebay right now. I have been meaning to pick up a few more myself after using my last ranger ejector on my last build. Just make sure that it it post 70's production because prior years were machined differently and will not fit.
I went looking and couldn't find them. Do you have a link to a specific listing?
Maybe you caused a run on eBay!
Where did it break?

M

Great question. It seems like a reasonably large and durable part.
Moon
Great question. It seems like a reasonably large and durable part.
Moon
That is a clue to WHY it broke.

M
I went looking and couldn't find them. Do you have a link to a specific listing?
Maybe you caused a run on eBay!
You are correct. The 2 that I saw have apparently been purchased. There were also a few on gunbroker if you care to pay $50+ for them (too expensive for me personally bur when you need a part...).
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top