Walther Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I bought a hi-cap magazine from a guy and it came in five pieces.
I'm not a mechanic and have never assembled a magazine before.
I think I get three of the five pieces, but is there a diagram out there anywhere?
Thanks in advance
 

·
Registered
Joined
·
11 Posts
http://www.lenaburgs.net/james/Guns/P99Manual.pdf

page 14... worth a try it JUST might be the same...lol

MAGAZINE DISASSEMBLY: BEFORE YOU START TAKE A GOOD LOOK at
the magazine, follower, and floorplate assembly so you can put them back
together again in proper relationship.
In your accessory kit there is a magazine disassembly pin. Insert the narrow end
of the pin into the hole in the bottom of the magazine. Push in against the
pressure of the magazine spring and slide the floorplate assembly (the bottom
part of the magazine) forward about 1/4 inch. Take out the disassembly pin and
set it aside. Carefully controlling the magazine spring with your finger or thumb,
slide the floorplate assembly off and remove the spring, floorplate and follower
from the magazine. To reassemble, you do not need the disassembly pin.
 
1 - 3 of 3 Posts
Top