Walther Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
46 Posts
Discussion Starter · #1 ·
I noticed that my guide rod bends a little when I put it back after cleaning. I first noticed this when I tried to put the guide rod assembly back in after a thourough cleaning and was dismayed to see that the buffer area kinda bends do to pressing against the barrel groove. Does it sit bent like this when the slide is attached to the frame? I wouldnt think so but if it does, then this may be a problem in the future.

I know they have metal guide rods but my question isnt about metal guide rods. My question is wheter or not the guide rod bending is normal. And if it is, does it stay that way while attached to the slide.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top