Walther Forums banner

1 - 9 of 9 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Hello,

First post here. I have an Interarms PPK/S that when I bought it came with aftermarket grips. I've since bought factory grips for it but the grip screw that was with the aftermarket ones doesn't fit. I'm not sure though if it's because the screw doesn't fit the factory grips or if it's because I don't have the escutcheons. Is there a place I can get a grip screw for this? I tried ebay and gun broker but most of the auctions include the grips. Should've waited to find a set with the screw but I didn't
 

·
Super Moderator
Joined
·
7,312 Posts
There should be a metal liner in the right grip, and a threaded nut in the left. If these aren't present, Numrich should be able to help you on those as well.
Moon
 

·
Registered
Joined
·
275 Posts
That's the metal thingies. Not all grips come with them installed, so you might have to push them out of your customs and reinstall on the originals. They're probably held in by friction. I had to do this on my FN 1910.
 

·
Registered
Joined
·
2,910 Posts
A lot of aftermarket grips don't use the same screw, nut, and escutcheon set up that Walther does. I would guess Earl has the set available.
 

·
Registered
Joined
·
275 Posts
I guess not, but if the screw is the right length and the holes are the same and you can replace the nut and escutcheon with one that works, I don't see the problem.
 

·
Super Moderator
Joined
·
7,312 Posts
I've run into the compatibility thing with gripscrews, and they are hit-or-miss.
For the OP, are those pictures of the factory grips?
Moon
 

·
Registered
Joined
·
3 Posts
Discussion Starter #9
Moon,

Yes they are factory. They didn't come with the gun when I bought them but I recently did and they are factory grips.
 
1 - 9 of 9 Posts
Top