Walther Forums banner

Extractor roll pin

618 Views 1 Reply 2 Participants Last post by  1917-1911M
My fairly new P22CA has a loose extractor roll pin. It drops down from the top of the slide after a few shots. It doesn't drop all the way out, but it does hang down from the bottom of the slide about 1/8". I've tapped it up, but it doesn't stay.
Should I try some locktite?
Return for warrantee work?
Or, ????
1 - 2 of 2 Posts
That's a common problem. You can put a tiny dab of blue or red threadlocker on where it fits into the slide but you must degrease the roll pin and slide hole first. 1917
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.