Walther Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter · #1 ·
All of the brass out of my .40 P99 have a short - about 1/8" - mark/dent at about 45 degrees. I'd guess that it hits the top-right of the slide on the way out.

Sizing "mostly" squeezes the mark away.

Is this normal?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top