Walther Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I recently bought a used P99 40 S&W. I changed the front sight but cant get the screw into the sight I put on. Anyone have any suggestions or hints?
 

·
Registered
Joined
·
16 Posts
If it is a new plastic sight, it is unthreaded. All that you need to do is to install the sight and fit the set screw to the long end of the allen wrench. I then held the slide in me weak hand while putting pressure on the allen wrench to push the screw in while turning the wrench. A little pressure on the wrench pusing straight into the sights hole while starting the set screw makes all of the difference.

Good Luck.
 
1 - 2 of 2 Posts
Top