Walther Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9,555 Posts
Discussion Starter #1
I though it might be of interest to have a short statement of what owners are seeing on their pistols by serial number range.

Serial number range
Does your pistol have filing/grinding marks at the chamber entrance?
Is the bottom left side of your striker rail machined to the point there is a hole into the striker channel?
How is your pistol performing?
Ammo that preforms well, ammo that doesn't.

Perhaps just a short statement. I'm not sure any pistols are out at this time without the striker rail work. Some have reported no work on the chamber entrance. It seems that with the exception of a few pistols the CCP is performing well. M1911
 

·
Registered
Joined
·
289 Posts
Serial number range: 36xx
Does your pistol have filing/grinding marks at the chamber entrance? Yes
Is the bottom left side of your striker rail machined to the point there is a hole into the striker channel? Yes
How is your pistol performing? no comment :D
Ammo that preforms well, ammo that doesn't: 50rds Blazer Brass 115gr FMJ was flawless, Slovak ZVS 115gr FMJ had a couple FTE in 50rds, Corbon 124gr +P JHP 7rds no failure, 1rd Federal 124gr HST JHP and striker spring failure.
 

Attachments

1 - 5 of 5 Posts
Top