Walther Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Is normal some marks in barrel's feed ramp 9mm,(400 rounds) the mark are  more deep in the edges feed ramp, the form of marks is like a arcs that cross edge to edge.

Thanks.
 

·
Registered
Joined
·
17 Posts
Discussion Starter · #3 ·
I have not camera, but the feed ramp  look  rough  with this "lines" that cross edge to edge and are  more deep to the edge.

Thanks

MX
 

·
Registered
Joined
·
411 Posts
Both of my P99's feed ramps are smooth and polished looking.
 

·
Registered
Joined
·
1,256 Posts
I had one P99 that had a few machine lines on the feed ramp, but they didn't effect feeding.
 

·
Registered
Joined
·
17 Posts
Discussion Starter · #8 ·
Thanks for information, in the pic of Bibon I made in circle the  site of  mark,  I have not problem, but is posible that some type of ammunition cause this mark?
 

·
Registered
Joined
·
1,256 Posts
Those look like machine marks to me. Done at the factory. I'm 99.9% sure that ammo won't cause that.
 
1 - 9 of 9 Posts
Top