Walther Forums banner
1 - 14 of 14 Posts

· Registered
Joined
·
356 Posts
Discussion Starter · #1 ·
They're here! They arrived this morning. I took some photos of one, along side a factory .40 Auto barrel.













I put 200 rounds through one of mine (I bought two) today. Flawless and accurate. One of my ten-shot groups (10 yards with two-hand hold) was one-inch, or counting one flyer it becomes 1.5 inches. I am impressed with this barrel.
 

· Registered
Joined
·
28 Posts
Hello All,

I ran both my barrels today with one FTF caused by the Canned Heat ammo.

With the big HiViz front sight on both pistols, I was able to consistantly "clang" the chicken at 25 yards. It became boring and matter of fact.

TQM
 

· Registered
Joined
·
356 Posts
Discussion Starter · #9 ·
[b said:
Quote[/b] (SR90746 @ Mar. 16 2003,3:16)]If I buy a .40 P99, can I get a 9mm and 357 Sig barrel for it ?
You can at least get a .357 Sig barrel for it. Theoretically, Bar-Sto can eventually make 9mm conversion barrels, but I have no idea what the timing would be. You should contact Bar-Sto to inquire.
 

· Registered
Joined
·
356 Posts
Discussion Starter · #14 ·
The barrels retail for $200. However, because we had a large number of barrels in the order (29), and because we place the order during 2002, we got 20% off the 2002 price ($195). So, the barrels worked out to be $156 a pop, without shipping. I took care of shipping from Bar-Sto to me, and charged $4 for shipping to those who went in on it. So, $160 total.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top