[Hal8000]

Has any one discovered how to change the Anit-Stress trigger into the Traditional Action trigger...

Reading on a previous post, the difference is the "hump" you get in the first SA shot with the AS system... That little hump is there by design... Although I like the AS trigger, if that little "hump" was not there, it would not bother me in the least...

I'm hoping it's as simple as "oh yeah, just remove this little piece of plastic right here"... I know that may be a bit too much to wish for, but it sure can't hurt to hope, right?

Ideas???

 

[Hal8000]

Yeah, I'm not very good with the written word, sorry about that...

In single action, the first time you pull the trigger it goes through a "stage", and it clicks about half way. I called it a "hump", maybe bad terminology... It only does it the first time after cocking your gun... That is part of the "Anti-Stress" system... I'd like to smooth it out... The later shots have a much shorter reset/pull...

Navy87Guy, your right, you need your P99, you'll see... It's not really too pronounced, and not too bothersome... I just know Walther has made them without the hump/click and it's called the TA, Traditional Action...

I'm not wanting to do any major changes with a pretty darn good system, but if there is a way, with little modification, that wont effect reliability, I'm willing to listen...