Walther Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10,583 Posts
I have a hard time making one stay put as well. After really tightening a Q model down it still walked forward 1/2" in a thousand rounds. It is possible to stretch the original by over tightening and then it won't stay tight. I always install with no oil under it. I've never tried it but I expect removing the lubricant from the inside of the stabilizer and the barrel sleeve and then applying a thin coat of weak blue thread locker might help. You will have to let the thread locker cure. I wouldn't use red. If it gets too bad call Ft Smith and ask for a new one. It seems that a groove or something in the barrel sleeve would have been a good addition to index and hold the part in place. 1917
 

·
Registered
Joined
·
10,583 Posts
Let us know how it works out. The stabilizer has always been a problem..you have to remove it to field strip also. What the 5"barrel needs is a five inch slide. Guess you will have to go with the PPQ 5" .22 for that. 1917
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top