Walther Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
So, the specs on Earl's website says the following about the widths of the guns:

P99 (presumably the original version) - 1.14" (29mm)

P99AS (I'm assuming this is the '04 model) - 1.25" (32mm)

So does anyone know where the gain in girth occured? Is it the slide?

I ask because I'm trying to get a holster made. It will be kydex and 3mm may make a big difference in fit (then again, it may not).
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top