Walther Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. The Classics
    I need a hammer for a Model 4 Varient 2. Any assistance would be greatly appreciated.
  2. PK380
    I purchased a PK380 about 8 months ago and last night while i was cleaning it, i think i might of run into a problem but i'm not sure. I know a lot about firearms, but i am no expert on PK380's so i thought i would ask the community. Any advice or information is appreciated. My problem is after...
  3. PP and TP Series
    Moderator Note: This discussion combines two threads on the same subject that were running at the same time. I merged the two hoping they would make sense... Milspec :D . ______________________________________ I am trying to find a "hammer release" for a pre war PP (I think 1939 vintage)...
  4. PP and TP Series
    Greetings all. I've been wanting a PPK for a couple of years. I found a .380 in a pawn shop in Tulsa yesterday. Turns out it's a 1997 or 98 Interarms (which is what I wanted) and the price was about $100 cheaper than what I've seen on a local board or on Armslist. It had been well used and...
  5. PP and TP Series
    Hello all, I've been having a Walther PPK/S 380 APC 9mm kurz for many years. It's been manufactured by Interarms and has a ser. no. S157171. I've bought it in 1999. I was at the shooting range and had it inspected there. I was told that it has an issue with the hammer. Its clearance is too big...
  6. The Classics
    I have a Walther Model 4 that I would like to plink with some but also be able to conceal carry. However, the hammer on it was broken and was repaired by putting a screw in it by the owner before me, which no longer works. I've been looking all over the internet, tried Numrich, Gunbroker, even...
1-6 of 6 Results