Model 8 firing pin 1st Issue ? - WaltherForums

Go Back   WaltherForums > Walther Firearms > The Classics > FAQ: The Classics

LinkBack Thread Tools Display Modes
Old 07-27-2018, 10:20 AM   #1
Junior Member
Join Date: Jul 2018
Location: NJ,USA
Posts: 2
GeeReg .22
Model 8 firing pin 1st Issue ?

i am looking for the firing pin ,my pistol is a first release with the internal extractor that holds the breech block in . My pin is one piece .od .156 necked down to .098 and that starts around .880 from the hammer stricking face and the notch for the extractor starts at.135 from the same hammer face and is .278 wide . I dont have an over all lenth since mine is broken . I relieze this would be hard to find but if someone could tell me the over all lenth i could make my own ,or even just how much of the pin sticks out of the breetch face on someones existing gun with out having to take it apart since its a pain and the extractor is so fragile would be good enough for me to figure out the pin overall lenth . Thanks , G
GeeReg is offline   Reply With Quote

Lower Navigation
Go Back   WaltherForums > Walther Firearms > The Classics > FAQ: The Classics

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.