|
02-21-2012, 04:33 PM
|
#11 |
|
Junior Member
Join Date: Jun 2010
Location: Roswell, GA
Posts: 27
 |
I got a stainless one made for me by Steve Bedair for my SW99 in .45. I only did it because the original plastic rod had bent to the point where it was difficult to field strip.
Steve Bedair Stainless Guide Rods |
|
|
|
02-21-2012, 11:28 PM
|
#13 | |
|
Member
Join Date: Feb 2012
Location: NC
Posts: 48
|
Quote:
__________________
The world is a dangerous place. Not because of the evil but because of those who choose to do nothing about them. - Albert Einstein Walther PPQ .40 S&W, P220 W.Germ, CZ 75B, FNP 45, G36, G26, LC9, SP101 3", GP100 4", Rem 870 20g |
|
|
|
|
 |
Lower Navigation
|
||||||
|
||||||
| Search tags for this page |
any forums on bt guiderods,b-t guide rods,bt guide rod,bt guide rod reviws,bt guide rods,bt guiderods,guide rod p99c,p99 guide rod,p99 guide rod walther,p99 guide rods,p99 metal guide rod,sw99 guide rod 45,walther guide rods,where are bt guide rods made? |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
